Icom IC-V80 Instruction Manual - Page 25

BASIC OPERATION 4 R WARNING! When using the BP-263 battery case, frequent or continuous transmissions can cause the batteries to overheat, and may cause a burn. To prevent this, the default time-out timer is set to 5 minutes (p. 44). Be careful when the time-out timer function is turned OFF or set to a long time period, and transmission is made for long periods. • We recommend using the middle or low power setting. ■ Key lock function To prevent accidental frequency changes, or unnecessary function access, use the key lock function. ➥ Push [FUNC](M), and then push and hold [ ](# ENT) for 1 sec. to turn the key lock function ON or OFF. • " " appears while the key lock function is activated VOL], [MONI], [PTT] and [FUNC](M) + [ ](# ENT) are still operable while the key lock function is ON. Appears ■ [VOL] function assignment 1 [VOL] can be used as a tuning control instead of [] and 2 [], to suit your preference. However, when [VOL] functions 3 as a tuning control, [] and [] function as volume controls. 4 q W hile pushing and holding [] and [], turn the power 5 ON to enter the Initial Set mode. w Push [] or [] to select the dial assignment item. (tOP) 6 e R otate [VOL] to select an option. r Push [# ENT] to exit the Initial Set mode. 7 8 [VOL] 9 10 [VOL] functions as the volume control. 11 12 13 14 [VOL] functions as the tuning control. 15 [VOL] and function as described below, depend- 16 ing on the option. 17 Option [VOL] []/[] 18 tOP.VO Volume control Tuning controls tOP.di Tuning control 19 Volume controls 18