Icom IC-V80 Instruction Manual - Page 47

SET MODES 10 D Frequency offset Selects the frequency offset between 0 and 20 MHz, for re- peater operation. The frequency offset means the difference between the transmit and receive frequencies. (default: differs depending on the version) D Reverse duplex function Turns the reverse duplex function ON or OFF. (default: OFF) D Tuning step Selects the tuning step from 5, 10, 12.5, 15, 20, 25, 30 and 50 kHz. (default: differs depending on the version) D Scan resume setting 1 Selects the scan resume setting between SCt. 5, SCt. 10, 2 SCt. 15, and SCP. 2. When a signal is received during a scan, the scan pauses 3 and then resumes, according to the scan resume setting. 4 • SCt. 5/10/15 : The scan pauses for 5, 10 or 15 sec., and then re- sumes. (default: SCt. 15) 5 • SCP.2 : The scan pauses until the received signal disappears, and then resumes after 2 sec. 6 7 8 9 D Function key timer 10 Push [FUNC](M) to enter the Function mode, and then push a keypad key to activate it's second function. 11 • During the Function mode, " " is displayed on the LCD. Set the time between when Function mode is entered, and 12 how long it remains activated after you push the keypad key 13 to activate it's second function. • F0.At : Exits the Function mode immediately after a key is 14 pushed to activate it's second function. (default) 15 • F1/2/3.At : The Function mode remains activated for the selected pe- riod after a key is pushed to activate it's second function. 16 • F .m : The Function mode remains activated until [FUNC](M) is pushed again, even after a key is pushed to activate 17 it's second function. 18 19 40