Intel DH61AG Technical Product Specification - Page 88
Front-panel Power LED Blink Codes, BIOS Error Messages - replacement
View all Intel DH61AG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Intel Desktop Board DH61AG Technical Product Specification 4.3 Front-panel Power LED Blink Codes Whenever a recoverable error occurs during POST, the BIOS causes the board's front panel power LED to blink an error message describing the problem (see Table 52). Table 52. Front-panel Power LED Blink Codes Type Pattern BIOS update in progress Video error (Note) Off when the update begins, then on for 0.5 seconds, then off for 0.5 seconds. The pattern repeats until the BIOS update is complete. On-off (1.0 second each) two times, then 2.5-second pause (off), entire pattern repeats (blink and pause) until the system is powered off. Memory error On-off (1.0 second each) three times, then 2.5-second pause (off), entire pattern repeats (blinks and pause) until the system is powered off. Thermal trip warning Each beep will be accompanied by the following blink pattern: .25 seconds on, .25 seconds off, .25 seconds on, .25 seconds off. This will result in a total of 16 blinks. Note: Disabled per default BIOS setup option. Note When no VGA option ROM is found. 4.4 BIOS Error Messages Table 53 lists the error messages and provides a brief description of each. Table 53. BIOS Error Messages Error Message Explanation CMOS Battery Low The battery may be losing power. Replace the battery soon. CMOS Checksum Bad The CMOS checksum is incorrect. CMOS memory may have been corrupted. Run Setup to reset values. Memory Size Decreased No Boot Device Available Memory size has decreased since the last boot. If no memory was removed, then memory may be bad. System did not find a device to boot. 88