JVC KW-R930BTS Instruction Manual America - Page 30

AUDIO SETTINGS Speaker output settings [SPK/PRE OUT] (Applicable only if [X ' OVER TYPE] is set to [2-WAY]) ( 25) Select the output setting for the speakers [SPK/PRE OUT], based on the speaker connection method. Connection via lineout terminals For connections through an external amplifier. ( 39, 40) Setting on [SPK/PRE OUT] Audio signal through lineout terminal FRONT REAR SW REAR/REAR (default) Front speakers output Rear speakers output Subwoofer output SUB.W/SUB.W Front speakers output L (left): Subwoofer output Subwoofer output R (right): (Mute) Connection via speaker leads For connections without using an external amplifier. However, with this settings you can also enjoy the subwoofer output. ( 39) Setting on [SPK/PRE OUT] REAR/REAR Audio signal through rear speaker lead L (left) R (right) Rear speakers output Rear speakers output SUB.W/SUB.W Subwoofer output (Mute) If [SUB.W/SUB.W] is selected: - [120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available. - [POSITION R02] is selected in [FADER] and selectable range is [POSITION R15] to [POSITION 00]. Crossover settings Below are the available setting items for 2-way crossover and 3-way crossover. Caution Select a crossover type according to how the speakers are connected. ( 39, 40) If you select a wrong type: • The speakers may damage. • The output sound level may be extremely high or low. SPEAKER SIZE Selects according to the connected speaker size for optimum performance. • The frequency and slope settings are automatically set for the crossover of the selected speaker. • When 2-way crossover is selected, if [NONE] is selected for [TWEETER] of [FRONT], [REAR] and [SUBWOOFER] for [SPEAKER SIZE], the [X ' OVER] setting of the selected speaker is not available. • When 3-way crossover is selected, if [NONE] is selected for [WOOFER] of [SPEAKER SIZE], the [X ' OVER] setting of [WOOFER] is not available. X ' OVER (crossover) • [FRQ]/[F-HPF FRQ]/[R-HPF FRQ]/[SW LPF FRQ]/[HPF FRQ]/[LPF FRQ]: Adjusts the crossover frequency for the selected speakers (high pass filter or low pass filter). If [THROUGH] is selected, all signals are sent to the selected speakers. • [SLOPE]/[F-HPF SLOPE]/[R-HPF SLOPE]/[SW LPF SLOPE]/[HPF SLOPE]/[LPF SLOPE]: Adjusts the crossover slope. Selectable only if a setting other than [THROUGH] is selected for the crossover frequency. • [SW LPF PHASE]/[PHASE]: Selects the phase of the speaker output to be in line with the other speaker output. • [GAIN LEFT]/[GAIN RIGHT]/[F-HPF GAIN]/[R-HPF GAIN]/[SW LPF GAIN]/[GAIN]: Adjusts the output volume of the selected speaker. 26 ENGLISH