JVC KW-R930BTS Instruction Manual America - Page 39
Echo Cancel]
View all JVC KW-R930BTS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
TROUBLESHOOTING Bluetooth® SiriusXM® Radio Symptom "CH UNAVAIL" "CHECK ANTENNA" "CHECK TUNER" "NO SIGNAL" "SUBSCRIPTION UPDATED - PRESS ENTER TO CONTINUE." "CODE ERROR" "NO CONTENT" "SCAN CANCEL" No Bluetooth device is detected. Pairing cannot be made. Echo or noise occurs. Phone sound quality is poor. Remedy The selected channel is unavailable. For more information about the SiriusXM channel lineup, visit . Check that the antenna and its connection are in good condition. Make sure the SiriusXM Vehicle Tuner is connected to the unit. Make sure the antenna is mounted outside the vehicle. Your subscription is updated. Press the volume knob to continue. Make sure you have entered the correct pass code. ( 14) There is insufficient content to start TuneScan. TuneScan has been aborted. • Search from the Bluetooth device again. • Reset the unit. ( 3) • Make sure you have entered the same PIN code to both the unit and Bluetooth device. • Delete pairing information from both the unit and the Bluetooth device, then perform pairing again. ( 15) • Adjust the microphone unit's position. ( 15) • Check the [ECHO CANCEL] setting. ( 17) • Reduce the distance between the unit and the Bluetooth device. • Move the car to a place where you can get a better signal reception. Symptom Remedy Sound is being interrupted • Reduce the distance between the unit and the Bluetooth or skipped during playback audio player. of a Bluetooth audio • Turn off, then turn on the unit and try to connect again. player. • Other Bluetooth devices might be trying to connect to the unit. The connected Bluetooth audio player cannot be controlled. • Check whether the connected Bluetooth audio player supports Audio/Video Remote Control Profile (AVRCP). (Refer to the instructions of your audio player.) • Disconnect and connect the Bluetooth player again. Bluetooth® "PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the message does not disappear, turn off and turn on the unit, then connect the device again. "NOT SUPPORT" The connected phone does not support Voice Recognition feature. "ERROR" Try the operation again. If "ERROR" appears again, check if the device supports the function you have tried. "H/W ERROR" Reset the unit and try the operation again. If "H/W ERROR" appears again, consult your nearest service center. "SWITCHING NG" The connected phones might not support phone switching feature. If you have any troubles, try the following: 1 Check TROUBLESHOOTING 2 Reset the unit ( 3) 3 Contact (USA only) Call: 1-800-252-5722 ( or ) visit: ENGLISH 35