JVC M505 Instructions - Page 15

Connections Note that the illustration below is for TH-M505. Before connecting the speaker cords; Twist and pull the insulation coat off and remove. Powered subwoofer ( ) TH-M505: SP-PWM505 TH-M501: SP-PWM501 Front speakers ( ) TH-M505: SP-THM505F*1 TH-M501: SP-THM303F*2 This page is for Speaker cord (supplied) • Connect the silver cords to the black (r) terminals. • Connect the copper cords to the (q) terminals referring to the table below: FRONT SPEAKERS (RIGHT) Red FRONT SPEAKERS (LEFT) White CENTER SPEAKER Green SURROUND SPEAKERS (RIGHT) Gray SURROUND SPEAKERS (LEFT) Blue 4 m (13 feet) Surround speakers ( ) TH-M505: SP-THM505S*1 TH-M501: SP-THM303S*2 (Bottom) 4 m (13 feet) Center speaker ( ) TH-M505: SP-THM505C*1 TH-M501: SP-THM303C*2 10 m (33 feet) *1 For TH-M505 Silver Copper *2 For TH-M501, the satellite speakers are equipped with their speaker cords attached directly to their speaker unit instead of having speaker terminals on their cabinet. Red Black Front/Center speakers Surround speakers Route the speaker cord through the hole on the bracket. CAUTION • When you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer. • DO NOT connect more than one speaker to one speaker terminal. • When installing the satellite speakers on the wall; • Be sure to have them installed on the wall by a qualified personnel. DO NOT install the satellite speakers on the wall by yourself to avoid unexpected damage from their falling off the wall due to incorrect installation or weakness in wall structure. • Care must be taken in selecting a location for speaker installation on a wall. Injury to personnel or damage to equipment may result if the speakers installed interfere with daily activities. Continued on next page 12