JVC M505 Instructions - Page 21

Basic operations The buttons on the remote control are used to explain most of the operations in this manual. You can use the buttons on the center unit same as on the remote control for operations unless otherwise noted. IMPORTANT Before using the remote control for the following operation; • Set the remote control mode selector to AUDIO. The buttons described below are used on pages 18 to 21. Turning the system on/off On the remote control: Press F AUDIO. On the center unit: Press F. When DVD is selected as the source (A pg. 19), the following messages will appear on the TV screen. Source selecting buttons Cursor (3/2/Y/5)/ ENTER Remote control mode selector • "OPEN"/"CLOSE": Appears when opening or closing the disc tray. • "NOW READING": Appears when the system is reading the disc information. • "REGION CODE ERROR!": Appears when the Region Code of the DVD VIDEO does not match the code the system supports. The disc cannot be played back. • "NO DISC": Appears when no disc is loaded. • "CANNOT PLAY THIS DISC": Appears when unplayable disc is loaded. NOTE • The STANDBY lamp turns on when the power is turned off and turns off when the power is turned on. • The power supply to the subwoofer is linked to the center unit. The POWER ON lamp on the subwoofer lights green when the power is turned on. • A small amount of the power is consumed even when the power is turned off (center unit only). This is called standby mode and the STANDBY lamp lights in this mode. Unplug the power cord from the AC outlet to turn the power off completely. • You can also turn on the system by pressing the following buttons; • One of 0 buttons on the center unit • One of the source selecting buttons on the remote control • One of the DISC (1-5) 3 buttons or 3 on the center unit. You can use the same buttons on the remote control except after pressing FM/AM. 18