JVC M505 Instructions - Page 19

Operating external components with the remote control The buttons described below are used on pages 16 and 17. 4 Press number buttons (1-9, 0) to enter the manufacturer's code (2 digits). Examples: For a Hitachi TV: Press 1, then 0. For a Toshiba TV: Press 0, then 8. Remote control mode selector (play button) Manufacturer JVC Hitachi Magnavox Mitsubishi Panasonic RCA Code Manufacturer 01 Samsung 10 Sharp 02 Sony 03 Toshiba 04, 11 Zenith 05 Code 12 06 07 08 09 5 Release F TV. If there is more than one code listed for corresponding brand, try each one until you enter the correct one. Number buttons NOTE • Manufacturers' codes are subject to change without notice. • Set the codes again after replacing the batteries of the remote control. 7 Operation Aim the remote control at the TV. IMPORTANT Before using the remote control to operate a TV; • Set the remote control mode selector to TV. The following buttons are available: F TV: Turns TV on and off. TV VOL +/-: Adjusts the volume. TV/VIDEO: Selects the input mode (either TV or VIDEO). CHANNEL +/-: Changes the channels. 1-10, 0, +10 (100+): Selects the channel. TV RETURN: Alternates between the previously selected channel and the current channel. Operating the TV 7 To set the manufacturer's code You can operate a JVC TV without setting the manufacturer's code. 1 Slide the remote control mode selector to TV. 2 Press and hold F TV. Keep the button pressed until step 4 is finished. 3 Press ENTER. Operating the DBS tuner or CATV converter 7 To set the manufacturer's code 1 Slide the remote control mode selector to VCR/DBS. 2 Press DBS. 3 Press and hold F VCR/DBS. Keep the button pressed until step 5 is finished. 4 Press ENTER. Continued on next page 16