Konica Minolta Fujitsu fi-7160 Operation Guide - Page 180
Resetting the sheet counters, Click the [OK] button in the Software Operation Panel.
View all Konica Minolta Fujitsu fi-7160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
Chapter 9 Operational Settings Item Remaining Ink Description Amount of ink remaining in the print cartridge of the imprinter (Only displayed when imprinter is installed) ATTENTION If the scanner was turned off by unplugging the power cable, or [Disable power switch] is selected, the number of scanned sheets may not be counted in [Total Page Count]. For details about disabling the power switch, refer to "Method of Turning the Scanner ON/OFF [Power SW Control]" (page 204). ■Resetting the sheet counters When you have replaced or cleaned a consumable part, reset the corresponding counter by using the following procedure. 1 If you have replaced a consumable, click the [Clear] button of the consumable that you replaced. If you performed cleaning, click the [Clear] button of [After cleaning]. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan The counter is reset to 0. For ink counter, the value will be set to 100. 2 Click the [OK] button in the Software Operation Panel. A confirmation message appears. 3 Click the [OK] button. The settings are saved. Daily Care Replacing the Consumables Troubleshooting Operational Settings Appendix Glossary 180