Konica Minolta Kodak i730 User Guide - Page 28

Image calibration, Kodak Scanner: i600

Get Konica Minolta Kodak i730 PDF manuals and user guides View all Konica Minolta Kodak i730 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Image calibration Use the calibration target provided with your scanner. Be sure to use a good, clean calibration target. Additional calibration targets can be ordered. See Chapter 5, "Supplies and accessories" for ordering information. NOTE: The screens shown in this section are for the TWAIN Datasource. The screens displayed on your system may be different. 1. Open the pod and clean the imaging guides. Refer to the maintenance procedures in Chapter 5. 2. If the lamps have not been on, allow the lamps to warm up for 90 seconds. 3. Center the side guides in the elevator tray and output tray. 4. Place the calibration target in the elevator tray. 5. Open the Scan Validation Tool. 6. Select Kodak Scanner: i600 or Kodak Scanner: i700. The main Kodak Scanner window will be displayed. 3-12 A-61500 May 2010

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
3-12
A-61500
May 2010
Image calibration
Use the calibration target provided with your scanner. Be sure to use a
good, clean calibration target. Additional calibration targets can be
ordered. See Chapter 5, “Supplies and accessories” for ordering
information.
NOTE: The screens shown in this section are for the TWAIN
Datasource. The screens displayed on your system may be
different.
1.
Open the pod and clean the imaging guides. Refer to the
maintenance procedures in Chapter 5.
2.
If the lamps have not been on, allow the lamps to warm up for 90
seconds.
3.
Center the side guides in the elevator tray and output tray.
4.
Place the calibration target in the elevator tray.
5.
Open the Scan Validation Tool.
6. Select
Kodak Scanner: i600
or
Kodak Scanner: i700
.
The main
Kodak
Scanner window will be displayed.