Konica Minolta bizhub 3300P bizhub 3300P User Guide - Page 88

Use Timeouts Hibernate Timeout Disabled 1 hour 2 hours 3 hours 6 hours 1 day 2 days 3 days 1 week 2 weeks 1 month Timeouts Hibernate Timeout on Connection Hibernate Do Not Hibernate Timeouts Print Timeout Disabled 1-255 sec User's Guide To Set the amount of time the printer waits after a job is printed before it enters Hibernate mode. Notes: • Disabled is the factory default setting in all countries except European Union countries and Switzerland. • 3 days is the factory default setting for all European Union countries and Switzerland. • The setting is also disabled if the printer detects an active Ethernet connection, regardless of country. However, to enable the setting even with an active Ethernet connection, click Settings >General Settings >Hibernate Timeout on Connection >Hibernate. To wake the printer from Hibernate mode, try one of the following: • Press the Sleep button for less than three seconds if Press Sleep Button is set to Hibernate. • Press and hold the Sleep button for more than three seconds if Press and Hold Sleep Button is set to Hibernate. • Turn off the printer, and then turn it back on. Set the printer to Hibernate mode even if there is an active Ethernet connection. Note: Do Not Hibernate is the factory default setting. Set the amount of time in seconds the printer waits to receive an end-of-job message before canceling the remainder of the print job. Notes: • "90 sec" is the factory default setting. • When the timer expires, any partially printed page still in the printer is printed, and then the printer checks to see if any new print jobs are waiting. • Print Timeout is available only when using PCL emulation. This setting has no effect on PostScript emulation print jobs. - 88 -