Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 224 Offline with side-tri - Page 30
The CON Window
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
3 - The User Interface - The CONFIGURE Window The CONFIGURE Window The CONFIGURE machine. window lets you make changes to the configuration of the Some functions and buttons are only available at certain access levels, see "ACCESS LEVEL" on page 27. The CONFIGURE Window Buttons Operator Supervisor Button Hidden Information Active Visible MACHINE OPTIONS Touch MACHINE OPTIONS to view the general machine set-up. Some of the settings can be changed, depending on the current access level. - MEASUREMENT Select 'mm' or 'inch' as the unit of measurement. To get best accuracy, use millimetres to measure the set. - STITCH SENSOR There is a sensor that checks for stitches. Touch STITCH SENSOR to turn the stitch sensor on or off. The default setting is ON. - PRESET PAPER SIZES The preset paper sizes can be either ISO A sizes or US paper sizes. To select which preset paper sizes are available, touch the relevant button. - SIDE TRIM (P2T) Touch SIDE TRIM (P2T) to switch off communication to the Side-Trimmer. Only do this if the Side-Trimmer is disconnected. - PBS Touch BOOK STACKER to switch off communication INSTALLED to the Book Stacker. Only do this if the Book Stacker is disconnected. SHUTTLE This button is used by the service engineer. FORM SETUP This button is used by the service engineer. 26 Watkiss PowerSquare™224 User Manual