Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 224 Offline with side-tri - Page 78
REMOVE SET FROM, See Light Guard
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
5 - Error Conditions, Problems and Solutions - Message List Message Information Reference MOTOR CONTROLLER The drive motor controller is not NOT READY ready. If the problem continues, contact your service engineer. OPERATOR MAINTENANCE The machine needs routine main- See "Operator tenance by the operator. Maintenance" on page 95. REBOOT THE MACHINE Use the mains ON/OFF switch. Turn the machine OFF, then turn the machine ON. If the problem continues, then call your service engineer. REMOVE SET FROM FOLD AREA Open the folder cover and remove See "Jam in the the set. Folder or Former Area" on page 79. REMOVE SET STITCH AREA Open the folder cover and remove See "Jam in the the set. Stitch Area" on page 79. SHUTTLE MOTOR ERROR The light guard in the gathering area has been interrupted. Touch STOP. Open the folder cover and remove the paper. Close the folder cover and touch START to continue operation. See "Light Guard Interruption" on page 53 SHUTTLE MOTOR COMMS FAIL Use the mains ON/OFF switch. Turn the machine OFF, then turn the machine ON. If the problem continues, then call your service engineer. Sidelay axis moving The sidelay axis (size adjustment) is adjusting. This message clears when the adjustment is complete. If the message does not clear, touch ADVANCED > RE-REF. SIDELAY - No comms Use the mains ON/OFF switch. Turn the machine OFF, then turn the machine ON. If the problem continues, then call your service engineer. 74 Watkiss PowerSquare™224 User Manual