Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 224 Offline with side-tri - Page 54
Procedure - Refitting, Step 4 - remove the outer book supports, Step 1 - preparation
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
4 - Standard Tasks - Remove and re-fit the Side-Trimmer Book Supports Step 4 - remove the outer book supports There are two outer book supports. Remove one at a time. Hold each end of the outer book support and lift upwards. Remove the outer book support through the top of the machine. Repeat with the other outer book support. Outer book support Procedure - Refitting Step 1 - preparation Use PAPER SIZE to set the paper width See "PAPER SIZE" on page 20. to 365mm. Then use SIDE TRIM to set the side-trim See "SIDE TRIM" on page 21. dimension to 365mm. Open the top cover of the Side-Trimmer. See Figure 34 on page 48. Step 2 - fit the inner and outer book supports There are two outer book supports and two inner book supports. Re-fit one at a time. Refer to the illustrations on page 47. On each book support, there are semicircular cut outs at each end. Position the cut-outs over the fixing points. Press down on the book support so that it fits onto the fixing points. Fixing Repeat with the other book supports. Cut-out 50 Watkiss PowerSquare™224 User Manual