LG CR5765GD Owners Manual - Page 59
Cleaning The Sensors/charging Terminals
View all LG CR5765GD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
CLEANING THE SENSORS/CHARGING TERMINALS There are sensors on the Robot Cleaner that detect obstacles, stairways and the home station for charging the battery. In order to maintain the performance of the Robot Cleaner, regularly clean the sensors and charging terminals as follows: 1. Turn off the power switch on the rear side of the Robot Cleaner. If the Robot Cleaner activates unexpectedly, it may cause injury. 2. Lay a smooth cloth on the floor, remove the dust bin, and turn over the Robot Cleaner and put it on the cloth. ※ Make sure to remove the dust bin before rotating the main body. Otherwise, the dust in the dust bin may fall out. 3. U se a smooth cloth or cleaning brush to wipe the dust off each of the 3 cliff sensors, camera sensors and ultrasonic sensors and the charging terminal as described below. Upper camera sensor Ultrasonic sensors Obstacle detecting sensor window Detecting sensors of home station and Receiving sensors of remote controller Cliff detection sensors Charging terminals Charging terminals Bottom camera sensor Lens Tip • Do not clean the Robot Cleaner by directly spraying it with water, thinners, solvents, benzene, or any other liquids. • Call the service center if the sensor or charging terminal is damaged. Sensor and terminal damage can cause the product to malfunction. • Use the cleaning brush to clean the sensor/charging terminals. 59