Home » Lenovo Manuals » Desktops » Lenovo ThinkCentre M55e » Manual Viewer

Lenovo ThinkCentre M55e Hardware Maintenance Manual - Page 165

Replacing the front audio/USB assembly, Replacing the power switch/LED assembly

View all Lenovo ThinkCentre M55e manuals

Add to My Manuals
Save this manual to your list of manuals

Page 165 highlights

6. Connect the system fan assembly cable to the system fan connector on the system board. 7. Go to "Completing the FRU replacement" on page 160. Replacing the front audio/USB assembly 1. Remove the computer cover. See "Removing the cover" on page 129. 2. Remove the front bezel. See "Removing and replacing the front bezel" on page 133 3. Disconnect the front audio/USB assembly cable from the system board. See the system board illustration for your machine type at "Identifying parts on the system board" on page 130. 4. Note the front audio/USB assembly cable routing and remove the screw that secures the assembly to the chassis. 5. Remove the front audio/USB assembly. 6. Route the cable for the new front audio/USB assembly through the hole in the chassis and to the system board. 7. Install the front audio/USB assembly into the chassis and secure it with the screw. 8. Connect the front audio/USB assembly cable to the system board. 9. Reinstall the front bezel. 10. Go to "Completing the FRU replacement" on page 160. Replacing the power switch/LED assembly 1. Remove the computer cover. See "Removing the cover" on page 129. 2. Remove the front bezel. See "Removing and replacing the front bezel" on page 133 3. Disconnect the power switch/LED assembly cable from the system board. See the system board illustration for your machine type at "Identifying parts on the system board" on page 130. 4. Note the power switch/LED assembly cable routing and the position of the two LEDs. 5. Remove the switch and the LEDs from the bezel. 6. Route the cable for the new power switch/LED assembly through the hole in the chassis and to the system board. 7. Install the new power switch/LED assembly into the bezel. Make sure that the LEDs are in the correct position. 8. Connect the power switch/LED cable to the system board. 9. Reinstall the front bezel. 10. Go to "Completing the FRU replacement" on page 160. Replacing the CMOS battery If the CMOS battery fails, the date, time, and configuration information (including passwords) are lost. An error message is displayed when you turn on the computer. Chapter 9. Replacing FRUs (tower computers) 159

Section	Page
Contents	5
Chapter 1. About this manual	7
Important Safety Information	7
Important information about replacing RoHS compliant FRUs	8
Chapter 2. Safety information	9
General safety	9
Electrical safety	9
Safety inspection guide	11
Handling electrostatic discharge-sensitive devices	12
Grounding requirements	12
Safety notices (multi-lingual translations)	13
Chapter 3. General information	43
The ThinkVantage™ Productivity Center program	43
Additional information resources	43
Specifications	44
Types 8700, 8701, 8705, 8717, 8973, 8975, 8979, 8983, 8985, 8991, 8995, 9265, 9269, 9277, 9279, 9283, 9287, 9379, 9383, 9387,	44
Types 8013, 8702, 8706, 8716, 8970, 8972, 8976, 8980, 8982, 8986, 8992, 8994, 9266, 9276, 9278, 9282, 9286, 9288, 9374, 9378,	45
Chapter 4. General Checkout	47
Problem determination tips	47
Chapter 5. Diagnostics	49
PC-Doctor for Windows	49
PC-Doctor for DOS	49
Creating a diagnostic CD image	50
Creating diagnostic diskettes	50
Running diagnostics from the CD or diskettes	50
Running diagnostics from the Rescue and Recovery workspace	51
PC-Doctor for Windows PE	51
Running diagnostics from the Rescue and Recovery workspace	51
Navigating through the diagnostics programs	52
Running tests	52
Test results	52
Fixed disk advanced test (FDAT)	53
Quick and Full erase - hard drive	54
Viewing the test log	55
Chapter 6. Using the Setup Utility	57
Starting the Setup Utility program	57
Viewing and changing settings	57
Using passwords	57
User Password	57
Setting, changing, and deleting a user password	57
Administrator Password	58
Setting, changing, and deleting an administrator password	58
Selecting a startup device	59
Selecting a temporary startup device	59
Changing the startup device sequence	59
Exiting from the Setup Utility program	59
Chapter 7. Symptom-to-FRU Index	61
Hard disk drive boot error	61
Power Supply Problems	61
Diagnostic error codes	63
Beep symptoms	84
POST error codes	85
Miscellaneous error messages	87
Undetermined problems	88
Chapter 8. Replacing FRUs (desktop computers)	91
Rear connectors	92
Removing the cover	93
Locations	94
Identifying parts on the system board	95
Machine types 8013, 8716, 8976, 8986, 9266, 9282, 9374, 9384, 9646, and 9647	95
Machine types 8706, 8972, 8982, 8994, 9278, 9288, 9380, 9632, 9648, and 9649	96
Machine types 8702, 8970, 8980, 8992, 9276, 9286, 9378, and 9628	97
Replacing a memory module	97
Replacing the CMOS battery	100
Replacing the power supply	100
Replacing the system board	103
Types 8702, 8706, 8970, 8972, 8980, 8982, 8992, 8994, 9276, 9278, 9286, 9288, 9378, 9380, 9628, 9632, and 9649	103
Types 8013, 8716, 8976, 8986, 9266, 9282, 9374, 9384, and 9647	107
Replacing the microprocessor	111
Types 8702, 8706, 8970, 8972, 8980, 8982, 8992, 8994, 9276, 9278, 9286, 9288, 9378, 9380, 9628, 9632, and 9649	111
Types 8013, 8716, 8976, 8986, 9266, 9282, 9374, 9384, and 9647	114
Replacing the hard disk drive	118
Replacing an optical drive	121
Replacing the diskette drive	123
Replacing the power switch/LED assembly	125
Replacing the front panel card	127
Replacing the system fan assembly	128
Replacing a PCI adapter	130
Completing the FRU replacement	130
Chapter 9. Replacing FRUs (tower computers)	133
Rear connectors	134
Removing the cover	135
Locations	136
Identifying parts on the system board	136
Machine types 8700, 8717, 8979, 8991, 9269, 9283, 9383, 9631, and 9646	137
Machine types 8705, 8975, 8985, 9265, 9279, 9379, 9389, 9637, and 9648	138
Machine types 8701, 8973, 8983, 8995, 9277, 9287, 9387, and 9635	139
Removing and replacing the front bezel	139
Replacing the power supply	140
Replacing the system board	141
Types 8701, 8705, 8973, 8975, 8983, 8985, 8995, 9265, 9277, 9279, 9287, 9379, 9387, 9389, 9635, 9637, and 9648	141
Types 8700, 8717, 8979, 8991, 9269, 9283, 9383, 9631, and 9646	146
Replacing the microprocessor	149
Types 8701, 8705, 8973, 8975, 8983, 8985, 8995, 9265, 9277, 9279, 9287, 9379, 9387, 9389, 9635, 9637, and 9648	149
Types 8700, 8717, 8979, 8991, 9269, 9283, 9383, 9631, and 9646	153
Replacing a memory module	157
Replacing a PCI adapter	158
Replacing the hard disk drive	159
Replacing an optical drive	162
Replacing the diskette drive	163
Replacing the system fan assembly	163
Replacing the front audio/USB assembly	165
Replacing the power switch/LED assembly	165
Replacing the CMOS battery	165
Completing the FRU replacement	166
Chapter 10. FRU lists	167
Machine Type 8013	167
Machine Type 8700	175
Machine Type 8701	185
Machine Type 8702	195
Machine Type 8705	205
Machine Type 8706	217
Machine Type 8970	227
Machine Type 8972	236
Machine Type 8973	245
Machine Type 8975	254
Machine Type 8976	263
Machine Type 8979	270
Machine Type 8980	279
Machine Type 8982	288
Machine Type 8983	298
Machine Type 8985	307
Machine Type 8986	317
Machine Type 8991	325
Machine Type 8992	335
Machine Type 8994	345
Machine Type 8995	356
Machine Type 9265	365
Machine Type 9266	376
Machine Type 9269	385
Machine Type 9276	395
Machine Type 9277	403
Machine Type 9278	412
Machine Type 9279	423
Machine Type 9282	433
Machine Type 9283	441
Machine Type 9286	450
Machine Type 9287	458
Machine Type 9288	467
Machine Type 9374	476
Machine Type 9378	486
Machine Type 9379	495
Machine Type 9380	504
Machine Type 9383	513
Machine Type 9384	522
Machine Type 9387	534
Machine Type 9389	543
Machine Type 9628	553
Machine Type 9631	562
Machine Type 9632	573
Machine Type 9635	586
Machine Type 9637	596
Chapter 11. Additional Service Information	611
Security features	611
Hardware controlled Passwords	611
Operating system password	611
Vital product data	611
Management Information Format (MIF)	611
BIOS levels	612
Flash update procedures	612
Updating (flashing) BIOS from a diskette	612
Recovering from a POST/BIOS update failure	612
Power management	613
Automatic configuration and power interface (ACPI) BIOS	613
Automatic Power-On features	613
Appendix. Notices	615
Television output notice	616

Match case Limit results 1 per page

Connect the system fan assembly cable to the system fan connector on the

system board.

Go to “Completing the FRU replacement” on page 160.

Replacing the front audio/USB assembly

Remove the computer cover. See “Removing the cover” on page 129.

Remove the front bezel. See “Removing and replacing the front bezel” on

page 133

Disconnect the front audio/USB assembly cable from the system board. See

the system board illustration for your machine type at “Identifying parts on

the system board” on page 130.

Note the front audio/USB assembly cable routing and remove the screw that

secures the assembly to the chassis.

Remove the front audio/USB assembly.

Route the cable for the new front audio/USB assembly through the hole in the

chassis and to the system board.

Install the front audio/USB assembly into the chassis and secure it with the

screw.

Connect the front audio/USB assembly cable to the system board.

Reinstall the front bezel.

10.

Go to “Completing the FRU replacement” on page 160.

Replacing the power switch/LED assembly

Remove the computer cover. See “Removing the cover” on page 129.

Remove the front bezel. See “Removing and replacing the front bezel” on

page 133

Disconnect the power switch/LED assembly cable from the system board. See

the system board illustration for your machine type at “Identifying parts on

the system board” on page 130.

Note the power switch/LED assembly cable routing and the position of the

two LEDs.

Remove the switch and the LEDs from the bezel.

Route the cable for the new power switch/LED assembly through the hole in

the chassis and to the system board.

Install the new power switch/LED assembly into the bezel. Make sure that the

LEDs are in the correct position.

Connect the power switch/LED cable to the system board.

Reinstall the front bezel.

10.

Go to “Completing the FRU replacement” on page 160.

Replacing the CMOS battery

If the CMOS battery fails, the date, time, and configuration information (including

passwords) are lost. An error message is displayed when you turn on the

computer.

Chapter 9. Replacing FRUs (tower computers)

159