Lenovo ThinkCentre M55e Hardware Maintenance Manual - Page 74
Press F3 to review the log file, IDE signal cable
View all Lenovo ThinkCentre M55e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Diagnostic Error Code 020-198-XXX PCI test aborted 020-199-XXX PCI test failed, cause unknown 020-262-XXX PCI system error 025-000-XXX IDE interface Test Passed 025-00X-XXX 025-01X-XXX IDE interface failure 025-027-XXX IDE interface Configuration/Setup error 025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface failure 025-195-XXX IDE interface Test aborted by user 025-196-XXX IDE interface test halt, error threshold exceeded 025-197-XXX IDE interface test warning 68 Hardware Maintenance Manual FRU/Action 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 51 2. Flash the system and re-test. See "Flash update procedures" on page 606 3. Go to "Undetermined problems" on page 82 1. Go to "Undetermined problems" on page 82 2. Flash the system and re-test. See "Flash update procedures" on page 606 3. Replace component under function test 1. PCI card 2. Riser card, if installed 3. System board No action 1. IDE signal cable 2. Check power supply voltages 3. Reseat IDE signal cable 4. IDE device 5. System board 1. IDE signal cable 2. Flash the system. See "Flash update procedures" on page 606 3. Reseat IDE signal cable 4. IDE device 5. System board 1. IDE signal cable 2. Check power supply 3. Reseat IDE signal cable 4. IDE device 5. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 51 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test