Lexmark 12N0004 User's Guide - Page 97

29 Replacing the transfer belt Your printer monitors the life of your transfer belt. When the transfer belt reaches the end of its life, the printer displays 80 Belt Exhausted. This message indicates it is time for you to replace the transfer belt. For best print quality, make sure you replace the transfer belt when the printer displays 80 Belt Life Warning. Press Go to clear the message. The Supplies message appears on the second line of the display to remind you that supplies need attention. You can open the Supplies Menu to see 80 Belt Exhausted or 80 Belt Life Warning messages. The printer continues to display the Supplies message until you replace the transfer belt. To replace the transfer belt, use the following steps or the instruction sheet supplied with the transfer belt. Preparing for maintenance 1 Turn the printer on. 2 Follow the instructions in the table for the message your printer is displaying. Primary message 80 Belt Life Warning Secondary message Select = Replace Go = Continue 80 Belt Exhausted Select = Replace 80 Belt/Fuser Life Warning Select = Replace Go = Continue 80 Belt/Fuser Exhausted Select = Replace What you should do Press Select if you want to replace the transfer belt now. Press Go if you want to wait to replace the transfer belt. Press Select to replace the transfer belt. Press Select if you want to replace the transfer belt now. Press Go if you want to wait to replace the transfer belt. Press Select to replace the transfer belt. The Preparing for Maintenance message appears while the printer moves parts into position. After the parts are in position, the message Printer Ready for Maintenance appears, followed by Power Off to Replace Items. 3 Turn the printer off. 95