Lexmark C782 Help Menu Pages - Page 16

Setup, User's Guide - print both sides

Get Lexmark C782 PDF manuals and user guides View all Lexmark C782 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Media guide Page 3 of 3 • Do not load wrinkled, creased, damp, or curled media. • Flex, fan, and straighten media before you load it. • Do not use media that has been cut or trimmed by hand. • Do not mix media sizes, weights, or types in the same media source. • Make sure the recommended print side is face down when loading 500-sheet trays, and face up when loading the multipurpose feeder or the high capacity feeder, for simplex (single-sided) printing. • Keep media stored in an acceptable environment. See "Storing Media." • Do not remove trays during a print job. • Push all trays in firmly after loading them. • Make sure the guides in the trays are properly positioned for the size of media loaded. Make sure the guides are not placed too tightly against the stack of media. • Make sure all cables that connect to the printer are correctly attached. See the Setup sheet for more information. • If a jam occurs, clear the entire media path. See the User's Guide for information on the media path.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
Media guide
Page 3 of 3
•
Do not load wrinkled, creased, damp, or curled media.
•
Flex, fan, and straighten media before you load it.
•
Do not use media that has been cut or trimmed by hand.
•
Do not mix media sizes, weights, or types in the same media source.
•
Make sure the recommended print side is face down when loading 500-sheet trays, and face up when
loading the multipurpose feeder or the high capacity feeder, for simplex (single-sided) printing.
•
Keep media stored in an acceptable environment. See “Storing Media.”
•
Do not remove trays during a print job.
•
Push all trays in firmly after loading them.
•
Make sure the guides in the trays are properly positioned for the size of media loaded. Make sure the guides
are not placed too tightly against the stack of media.
•
Make sure all cables that connect to the printer are correctly attached. See the
Setup
sheet for more
information.
•
If a jam occurs, clear the entire media path. See the
User’s Guide
for information on the media path.