Lexmark Consumer Inkjet Setup Guide - Page 38
Check Tray 2, Check MP, Feeder, Attaching cables, Problem, Action, Ready, Installing the printheads
View all Lexmark Consumer Inkjet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Troubleshooting tips You get a Check Tray 2 paper jam message You get a Check MP Feeder paper jam message Attaching cables The paper jammed from tray 2. • Remove tray 2. • Gently pull the paper toward you. • If you feel resistance, push the paper down, and then pull it toward you. • Repeat pushing and pulling the paper until it is released. • Reinstall the tray and press Go. The paper jammed in the multipurpose feeder. • Pull the paper release lever toward the media and hold it. • Pull the media straight up. If the paper jammed inside the printer: • Remove the multipurpose feeder. • Pull out the jammed paper. • Reinstall the multipurpose feeder and press Go. Problem Action Unexpected characters print or characters are missing • Make sure the parallel cable or USB cable is firmly plugged into the printer. • Make sure the Ready message appears on the operator panel display before printing a job. Press Go to return the printer to Ready status. • Make sure there is media loaded in the printer. Press Go to return the printer to Ready status. Installing the printheads Problem You get a Missing Printhead message You need to re-install a printhead, but the carrier is at the far left Action The printhead is not installed correctly. Check that the printhead tab is installed under the arrow on the carrier slot. • Close the cover. • Press Menu> until the Utilities Menu appears. • Press Select. • Press Menu> until you see Change Printhead. • Press Select. • Open the cover. The carrier moves to the center of the printer. Congratulations! 35