Lexmark E322 User's Guide - Page 93
Con and print, TCP/IP, Step 1: Set the IP address, netmask and gateway - dhcp
UPC - 734646512169
View all Lexmark E322 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Configure and print TCP/IP Step 1: Set the IP address, netmask and gateway You must assign an IP address, netmask and gateway to the print server in order for other network devices to find it on the network. • If you have DHCP, the proper addresses are automatically assigned. To verify the assignment has happened, print a network setup page and make sure the IP address, netmask and gateway appear as non-zero. • If you don't have DHCP, there are other methods you can use to manually assign the address, such as static ARP and telnet, or a setup utility. DHCP This method automatically sets the IP address, netmask, gateway, host name, and WINS server using a Dynamic Host Configuration Protocol (DHCP) server. The DHCP server or a forwarding agent must be attached to the same IP subnet as the print server. Make sure the DHCP server has scope defined for the subnet. Ensure that the DHCP server provides the following options: 001 Netmask 003 Router 044 WINS/NBNS Server Netmask for IP subnet IP address of router (such as 9.10.8.250) IP address of WINS server If you are using a WINS server, telnet to port 9000 to set the print server host name. Print Server TCP/IP Setup Utility The Print Server TCP/IP Setup Utility is a simple way to set the IP address and other important IP parameters in a print server. You can set up one or many print servers using this method with no need to physically visit the printers. Requirements You must run the Print Server TCP/IP Setup Utility on a Windows 95/98/Me, Windows NT 4.0, or Windows 2000 workstation. The print server must be on the same physical subnet as your workstation. In other words, the Print Server Setup Utility cannot cross routers, bridges, and so forth. 91