Magnavox 50ML6200D User Manual - Page 34

Troubleshooting Tips Check this List of Symptoms and Suggested Steps To Take before requesting Service. You may be able to solve the problem yourself. If you face problems connecting the TV to external devices, please refer to the User Guide of the external device or call their service centers for help. Charges for TV installation and adjustments of customer controls are not covered under your warranty. SYMPTOMS Hookup Can't get external audio equipment to work with TV. SUGGESTED STEPS TO TAKE 1. SPDIF output audio only in digital mode and the audio equipment used must have the decoder. 2. Monitor Out Audio LR output audio for both analog and digital programs Installation Installation Installation Can't get the AV channels on the TV screen. TV Displays Wrong Channel or No Channels Above 13 Channel numbers do not follow the channel number of the programs. Press the AV button on the remote control repeatedly to select the desired AV channels. Note: SVHS can only be selected if a S-VHS device is connected and powered on. Go to TUNER MODE in the television menu and select the correct signal source, then perform the automatic installation again. (Refer to page 7). Go to TUNER MODE in the television menu and select the correct signal source, then perform the automatic installation again. (Refer to page 7). Installation Auto programing is Auto programing may take 20 to 40 minutes depending on the number of channels that are available. taking too long. Settings Error messages appear on the screen of TV: No Signal No Program Audio Only Check that the antenna / cable is connected properly and that you have selected the correct tuner mode (refer to page 7). There could be temporarily no transmission on the selected channel.You may like to add these channels to the Weak Dig Sig. list. (refer to page 8). When transmission is resumed or when available, your TV will receive it. The current channel has only audio transmission. Sound Sound General 26 Disturbing sound (such as buzzing, clicking, cracking, humming, whistling, etc). Sound is not in Stereo. It is normal to hear a disturbing sound (such as buzzing, clicking, cracking, humming, whistling, etc) from a distance less than 2 meters (6 feet) with the television sound muted. If problem occurs on one channel, you may have a signal problem. Please contact the cable provider or local broadcaster regarding the specific channel. This could be due to any of the following reasons: 1. Not all transmitted broadcasts by the cable or broadcast stations are in STEREO.Try checking with several major network stations to be sure that the station you selected is in STEREO. 2. When SAP is turned ON, the sound mode is automatically set to MONO. 3. Sound mode is set to MONO. Set the sound mode to STEREO. (Refer to page 16). 4. When using an AV input, the television will not display STEREO even though it is producing stereo sound. No power to the Check the TV power cord. Unplug the power cord from the TV, wait 10 seconds, then reinsert the TV plug into your wall outlet. Power On the TV again. Plug the power cord directly to the wall socket and not via an extension cord. If you need to use an extension cord, check that the fuse on the AC power strip is not blown.