Marantz SR9600 SR9600 User Guide - Page 12

ENGLISH REMOTE CONTROLLER RC3200B NAMES AND FUNCTIONS 12 11 10 9 1 8 7 VOL OK CH 2 6 S 3 Ex M 5 4 F H (Mute) button Press this button to mute the sound temporarily. G VOL (Volume) up and down buttons Press these buttons to raise and lower the SR9600's volume level. H OK and cursor (Up/Down/Left/Right ) buttons Press these buttons to navigate through the OSD menu system. (Refer to "ON SCREEN DISPLAY MENU SYSTEM" on page 30) I Page up/down buttons Press these buttons to scroll up or down the contents of LCD touch screen. J Backlight ˆ button Press this button to turn on the backlight of the LCD touch screen. K Serial port Connect the RC3200B with your computer using an RS232C cable for future upgrades. LOADING BATTERIES When you use RC3200B for the first time, you have to install the batteries. The RC3200B requires 3 AA batteries (3 x 1.5 V) to function. Note: • The included batteries are for verifying functionality of the remote control unit. When replacing the batteries, either rechargeable or non-rechargeable batteries may be used. 1. Remove the back cover. 2. Insert the new batteries (AA type) with correct and polarity. CAUTIONS ON BATTERIES • Use "AA" (R6P) batteries in this remote control unit. • If the remote control unit does not operate from close to the main unit, replace the batteries with new ones, even if less then a year has passed. • The included battery is only for verifying operation. Replace it with a new battery as soon as possible. • When inserting the batteries, be careful to do so in the proper direction, following the marks in the remote control unit's battery compartment. - To prevent damage or battery fluid leakage: - Do not use a new battery with an old one. - Do not use two different types of batteries. - Do not short-circuit, disassemble, heat or dispose of batteries in flames. • Remove the batteries when not planning to use the remote control unit for a long period of time. • If the batteries should leak, carefully wipe off the fluid from the inside of the battery compartment, then insert new batteries. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. A Select buttons for navigation bar These buttons control the navigation bar in LCD touch screen. Each function may also be provided with an alphanumeric indicator visible in the navigation bar of LCD touch screen. B CH (Channel) up and down buttons Press these buttons to select the SR9600 tuner presets or TV channels. C S (Status) button Press this button to see the SR9600 status on the LCD touch screen. D M (Menu) button Press this button to enter the OSD menu system. E Ex (Exit) button Press this button to exit the OSD menu system. L LCD touch screen The LCD touch screen is divided into different sections: wed Jun 01 4:40pm 1/8 A/V Amp Source Select In this area, you can see the device you are operating. Operate your device with these soft buttons. 3. Close until it clicks. Notes: • Do not mix alkaline and manganese batteries. • Do not mix old and new batteries. REMOTE-CONTROLLABLE RANGE The distance between the transmitter/receiver of the remote control unit and the infrared sensor of the SR9600 should be less than about 16.4 ft (5 meters). If the transmitter/receiver is pointed away from the infrared sensor or if there is an obstacle between them, remote control may not be possible. 60° Remote control unit (RC3200B) A1p6p.r4oxft. (5 m) 10