Marantz SR9600 SR9600 User Guide - Page 28

ENGLISH CONNECTING THE ANTENNA TERMINALS AM LOOP ANTENNA AM EXTERNAL ANTENNA FM EXTERNAL ANTENNA FM FEEDER ANTENNA ANTENNA SPLITTER CONNECTING THE SUPPLIED ANTENNAS Connecting the supplied FM antenna The supplied FM antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion. If you experience poor reception quality, an outdoor antenna may improve the quality. DIGITAL IN (AUDIO) 7.1CH IN MAIN IN L SL SBL C L R SL SR SBL SBR C MULTI OUT A B L 1 S400 2 3 S400 4 5 6 R SR (AUX 2) L AUDIO R SBR DVD LD VIDEO S-VIDEO SW TV PRE OUT SW R AUDIO DSS TUNER-1IN TAPE OUT VCR-1 VCR-2 / DVD-R IN OUT IN OUT AM GND MONITOR OUT 1 2 IN CD-R/MD OUT CD MULTI OUT A B SPEAKER C ON OFF AM 7 VIDEO AM HDMI 8 Ver 1.1 INPUT-1 (DVD) INPUT-2 (DSS) OUTPUT TUNER-2 Y CB/PB CR/PR OUTPUT-1 INPUT-1 (DVD) INPUT-2 (DSS) INPUT-3 (VCR-1) INPUT-4 (VCR-2 / DVD-R) AM GND COMPONENT OPT VIDEO Y CB/PB CR/PR Y CB/PB CR/PR Y CB/PB CR/PR Y CB/PB CR/PR OUTPUT-2 CENTER SURR.BACK /MULTI SPK. /SPK. C LEFT SURR.BACK /MULTI SPK. /SPK. C RIGHT TUNER-1 GND FM(75Ω) TUNER-2 GND FM(75Ω) FRONT A LEFT FRONT A RIGHT FRONT B LEFT FRONT B RIGHT SURR. LEFT CLASS 2 WIRING SURR. RIGHT SWITCHED 1A 120W MAX SPEAKER SYSTEMS FRONT A OR B, CENTER, SURR, SURR BACK : MINIMUM 6 OHMS FRONT A AND B : MINIMUM 8 OHMS COAX 1 3 1 3 IR FLASHER RECEIVER IN IN IN MODEL NO. SR9600 UNSWITCHED 1A 120W MAX AC IN DIGITAL OUT USB AUDIO RS232C 2 4 2 4 DC OUT EMITTER OUT OUT RC-5 MULTI RC AC 120V 60HZ AC OUTLETS Connecting the supplied AM loop antenna The supplied AM loop antenna is for indoor use only. Set it in the direction and position it to where you receive the clearest sound. Put it as far away as possible from the unit, TVs, speaker cable, and power cord. If you experience poor reception quality, an outdoor antenna may improve the quality. 1. Press and hold down the lever on the AM antenna terminal. 2. Insert the bare wire into the antenna terminal. 3. Release the lever. Note: • Connect the shielded grounding wire (black) to the AM antenna GND terminal. ASSEMBLING THE AM LOOP ANTENNA 1. Release the vinyl tie and take out the connection line. 2. Bend the base part in the reverse direction. 3. Insert the hook at the bottom of the loop part into the slot at the base part. 4. Place the antenna on a stable surface. CONNECTING THE ANTENNA WIRE TO THE ANTENNA CONVERTER Loosen the screws and attach the wire terminals, then tighten the screws with a screwdriver. CONNECTING AN FM OUTDOOR ANTENNA Notes: • Keep the antenna away from noise sources (neon signs, busy roads, etc.). • Do not put the antenna close to power lines. Keep it well away from power lines, transformers, etc. • To avoid the risk of lightning and electrical shock, grounding is necessary. CONNECTING AN AM OUTDOOR ANTENNA An outdoor antenna will be more effective if it is stretched horizontally above a window or outside. Notes: • Do not remove the AM loop antenna. • To avoid the risk of lightning and electrical shock, grounding is necessary. 26