Marantz SR9600 SR9600 User Guide - Page 67

GENERAL MALFUNCTION If the equipment malfunctions, this may be because an electrostatic discharge or AC line interference has corrupted the information in the equipment memory circuits. Therefore: - disconnect the plug from the AC line supply - after waiting at least three minutes, reconnect the plug to the AC line supply - re-attempt to operate the equipment Memory backup • In case a power outage occurs or the power cord is accidentally unplugged, the SR9600 is equipped with a backup function to prevent memory data such as the preset memory from being erased. HOW TO RESET THE UNIT AV SURROUND RECEIVER SR9600 INPUT SELECTOR VOLUME STANDBY POWER ON/STANDBY PHONES PURE DIRECT THX DOWN TUNING UP BAND F/P SURROUND MODE AUTO MULTI MULTI SPEAKER AUTO TUNE T-MODE MEMORY CLEAR PURE DIRECT THX 7.1CH INPUT MENU ENTER DISPLAY EXIT MRAC SPEAKERS A/B MIC DOWN UP DIGITAL AUX 1 INPUT S-VIDEO VIDEO L AUDIO R Should the operation or display seem to be abnormal, reset the unit with the following procedure. With the SR9600 turned on, press and hold the MRAC and PURE DIRECT buttons simultaneously for 3 seconds or more. Remember that the procedure will reset the settings of the function selector, Surround mode, delay time (tuner preset) etc., to their initial settings. TECHNICAL SPECIFICATIONS FM TUNER SECTION Frequency Range 87.5 - 108.0 MHz Usable Sensitivity IHF 1.8 µV/16.4 dBf Signal to Noise Ratio Mono/Stereo 75/70 dB Distortion Mono/Stereo 0.2/0.3% Stereo Separation 1 kHz 45 dB Alternate Channel Selectivity 300 kHz 60 dB Image Rejection 98 MHz 70 dB Tuner Output Level 1 kHz, ± 75 kHz Dev 800 mV AM TUNER SECTION Frequency Range 520 - 1710 kHz Signal to Noise Ratio 50 dB Usable Sensitivity Loop 400 µV Distortion 400Hz, 30 % Mod. 0.5% Selectivity 20 kHz 70 dB AUDIO SECTION Power Output (20 Hz - 20 kHz/THD=0.08%) Front L&R 8 ohms 140 W/Ch Center 8 ohms 140 W/Ch Surround L&R 8 ohms 140 W/Ch Surround Back L&R 8 ohms 140 W/Ch Front L&R 6 ohms 170 W/Ch Center 6 ohms 170 W/Ch Surround L&R 6 ohms 170 W/Ch Surround Back L&R 6 ohms 170 W/Ch Input Sensitivity/Impedance 200 mV/ 47 Kohms Signal to Noise Ratio(Analog Input / Pure Direct) ...... 105 dB Frequency Response (Analog Input / Pure Direct 8 Hz - 100 kHz (± 3 dB) (Digital Input / 96 kHz PCM 8 Hz - 45 kHz (± 3 dB) VIDEO Television Format NTSC Input Level/Impedance 1 Vp-p/75 ohms Output Level/Impedance 1 Vp-p/75 ohms Video Frequency Response ....... 5 Hz to 8 MHz (- 1 dB) Video Frequency (Component) ... 5 Hz to 80 MHz (- 1 dB) S/N 60 dB HDMI Version 1.1 GENERAL Power Requirement AC 120 V 60 Hz Power Consumption 6.5 A Weight 57.3 lbs (26.0 Kg) ACCESSORIES Remote Control Unit RC3200B 1 Microphone MC-10 1 AA-size Batteries 3 FM Antenna 2 FM Antenna Adaptor 2 AM Loop Antenna 2 Front AUX Jack Cover 1 AC cable 1 RS232C Cable 1 Specifications subject to change without prior notice. DIMENSIONS 17-5/16 ins. (440 mm) AV SURROUND RECEIVER SR9600 INPUT SELECTOR VOLUME STANDBY POWER ON/STANDBY PHONES PURE DIRECT THX DOWN TUNING UP BAND F/P SURROUND MODE AUTO MULTI MULTI SPEAKER AUTO TUNE T-MODE MEMORY CLEAR PURE DIRECT THX 7.1CH INPUT MENU ENTER DISPLAY EXIT MRAC SPEAKERS A/B MIC DOWN UP DIGITAL AUX 1 INPUT S-VIDEO VIDEO L AUDIO R 3/4 ins. (18 mm) 7-7/8 ins. (200 mm) 8-5/8 ins. (218 mm) 13/16 ins. (20 mm) 17-5/16 ins. (440 mm) 19-1/16 ins. (483 mm) 15/16 in. (23 mm) 65 ENGLISH