Maytag MBL2256KES Use and Care Guide - Page 31
Automatic Ice, Maker, Connecting the Water Supply, Temperature Controls
UPC - 719881174099
View all Maytag MBL2256KES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Troubleshooting Ice Refrigerator is leaking water • Plastic tubing was used to complete water connection, • Improper water valve was installed. Ice forms in inlet tube to ice maker • Water pressure is low. • Freezer temperature is too high. Water flow is slower than normal • Water pressure is low. • Improper water valve was installed. Ice maker is not producing ice • Copper tubing has kinks. • Ice maker arm is in OFF position. • Household water supply is not reaching water valve. • Copper tubing has kinks. • Water pressure is too low. • Check freezer temperature. • The manufacturer recommends using copper tubing for installation. Plastic is less durable and can cause leakage. The manufacturer is not responsible for property damage due to improper installation or water connection. Check water connection procedure (see pages 910). Self-piercing and 3/,,,saddle valves cause low water pressure and may clog the line over time. The manufacturer is not responsible for property damage due to improper installation or water connection. Water pressure must be between 35 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters. Adjust freezer control (see pages 11-14). Freezer is recommended to be approximately 0° F (-17° C). • Water pressure must be between 35 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters. • Check water connection procedure in your Installation Instructions. Self-piercing and -%_" saddle valves cause low water pressure and may clog the line over time. The manufacturer is not responsible for property damage due to improper installation or water connection. Open water valve completely and check for leaks. Turn off water supply and remove kinks. If kinks cannot be removed, replace tubing. • Confirm ice maker arm is down. See Automatic Ice Maker, page 18. • See Connecting the Water Supply, pages 9-10. Turn off water supply and remove kinks. If kinks cannot be removed, replace tubing. Water pressure must be between 35 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for refigerators with water filters. • See Temperature Controls, pages 11-14. Freezer temperature should be between 0° to 2° F (-18 ° to -17 ° C) to produce ice. 30