Maytag MBL2256KES Use and Care Guide - Page 8

3. Locate handle trim in literature pack and install over top and bottom of handle, as illustrated. iii • Secure top handle trim with remaining screw removed in step 1. • Snap bottom trim over bottom portion of handle. To Remove: 1. Remove top handle trim by removing top handle screw. • Retain trim and screw for later replacement. 2. Pry bottom handle trim from handle with screwdriver flat blade wrapped in masking tape. • Retain trim for later replacement. 3. Remove two hex head screws. • Retain screws for later replacement. Side Mount Handle Materials Needed: • Phillips screwdriver To Install: 1. Remove screws from the side of the door. 2. Align the side mount handle with the predrilled holes in the door panel. 3. Insert the screws in the sequence as shown. Lowe r Handle 4. Ensure the door handle is snug to the door panel. To Remove: Reverse installation procedure. Freezer Handles Partial-Width Handle Materials Needed: • Phillips screwdriver To Install: 1. Install handle by fastening with screws removed from edge of door. • If reversing freezer door, remove door plugs from top edge of door and insert into screw holes. To Remove: 1. Remove handle screws with Phillips screwdriver and retain screws for later use. Front Mount Plastic Freezer Handle Notes: • There is a slight curve to this style of freezer handle. • For proper installation, be sure handle is oriented as shown. To Install: 1. Align door handle clips to the studs attached to the freezer door. Handle Door Stud 2. Ensure the large hole in the mounting clip is positioned to the right on both ends of the handle. 3. Rotate the handle so that the handle is flat against the door. 4. Grasp the handle firmly and slide handle to the right. To Remove: 1. With both hands, firmly grasp the handle toward the right side. 2. Slide toward the left, lift and remove from the surface.