Maytag MBL2256KES Use and Care Guide - Page 6

Pullout Freezer Drawer (select models) To Install: 1. Pull both rails out to full extension. 2. While supporting door front, hook supports into slots located on inside of each slide. Note: All four drawer bracket supports must be in the proper slots for the drawer to function properly. I Materials Needed: • Phillips screwdriver To Remove: 1. Pull drawer open to full extension. 2. Tilt the lower basket forward and lift to remove. 3. On each white drawer bracket is a basket cradle with two snap attachments. To release each cradle, unlatch the snaps by pushing them inward, away from the side bracket. Lift the cradles off of the rails. /4. Remove Phillips screw from each of the drawer slides (select models). 5. Lift top of drawer front to unhook the drawer from the slides. Lift door front out to remove. . Lower door front into final position. /4. Replace and tighten Phillips screws that were removed from the drawer slides (select models). . Place the basket cradles back onto the drawer slides. Align basket cradle snaps with the slots on the drawer brackets and press each cradle toward the bracket until it clicks. Basket cradle 6. Tilt the lower basket front down and set it down into the basket cradles.