Maytag MDG17CSAWW Installation Instructions - Page 12

2. Removheold-dowsncrewandtheterminablockcover. _D 3= Assemble 3/4" UL-listed strain relief (UL marking on strain relief) into the hole below the terminal block opening. Tighten strain relief screws just enough to hold the two clamp sections together. Install power supply cord through the strain relief. A. External ground conductor screw B. Tab C. Terminal block cover D. Hold-down screw A. Strain relief clamp sections B. Dryer cabinet C. Strain relief screws 4= Complete installation following instructions for your type of electrical connection: • Four-wire (recommended method) Three-wire (if four-wire is not available) Power Supply Cord, Four-wire electrical connection: B C D G f A. Spade terminalswithupturnedends E B.Neutral C.3/4"UL-listedstrainrelief D. Neutral(white) E. Ringterminals E Groundwire G.Groundprong Four-wire power supply cord must have four, No. 10 copper wires and match a four-wire receptacle of NEMA Type 14-30R. The fourth wire (ground conductor) must be identified by a green cover and the neutral conductor by a white cover. 5. Remove the center terminal block screw. 6. Remove the appliance neutral ground wire from the external ground conductor screw. Fasten under center, silver-colored terminal block screw. 7. Connect the ground wire of the power supply cord to the external ground conductor screw. Tighten screw. 8. Connect the neutral wire (white or center) of the power supply cord under the center screw of the terminal block. Tighten screw. 9. Connect the other wires to outer terminal block screws. Tighten screws. t0. Tighten strain relief screws. t 1. Insert tab of the terminal block cover into slot of the dryer rear panel. Secure cover with hold-down screw. A. External ground conductor screw B. Appliance neutral ground wire C. Center terminal block screw D. Outer terminal block screws E. Strain relief screw E Neutral (center wire) G. Ground wire 12