Maytag MEDE900VJ Use and Care Guide - Page 32

Cycle time too short Excessive Weight Hazard Use two or more people to move and install dryer. Failure to do so can result in back or other injury. Is the Sensor cycle ending early? The load may not be contacting the sensor strips. I.evel the dryer. Change the dryness [eve[ setting on Sensor Cycles. Increasing or decreasing the dryness [eve[ will change the amount of drying time in a cycle. Lint on load • Is the lint screen clogged? Clean lint screen. Check for air movement. Stains on load or drum • Was dryer fabric softener properly used? Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added to a partially dried load can stain your garments. I)rum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to other clothing. Loads are wrinkled Was the load removed from dryer at the end of the cycle? Select the Custom Refresh Cycle to tumble the load with water and heat to help smooth out wrinkles from a load [eft in the dryer. Was the dryer overloaded? Dry smaller loads that can tumble freely. Odors Have you recently been painting, staining or varnishing in the area where your dryer is located? If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry the clothing. • Is the dryer being used for the first time? The new electric heating element may have an odor. The odor will be gone after the first cycle. 32