Maytag MHW9000YG Use & Care Guide - Page 14

13. R emove garments promptly after cycle is finished Promptly remove garments after cycle has completed to avoid odor and rusting of metal objects on garments. When unloading garments, pull back the door seal and check for small items between the tub and the basket. If you will be unable to remove the load promptly, use the Fresh Hold™ option. If the Fresh Hold™ option is selected, the washer will automatically activate the fan and tumble the load periodically for up to 16 hours. NOTE: n After any wash cycle is completed, the door must be opened and then closed before a new cycle can begin. n A small amount of water may remain in the dispensers after the wash cycle is complete. This is normal. n This washer has a tight seal to avoid water leaks. To avoid odors, leave the door open to allow the washer to dry between uses. WASHER MAINTENANCE CLEANING YOUR WASHER Keep your washer as clean and fresh as your clothes. To keep washer interior odor-free, follow this recommended cleaning procedure at least once a month: 1. Make sure laundry drum is empty. 2. Using recommended affresh® washer cleaner, add one tablet to washer basket OR If using liquid chlorine bleach, add 1 cup (240 mL) to liquid chlorine bleach dispenser. IMPORTANT: Do not add detergent to CLEAN WASHER cycle. Do not use more than recommended amount of bleach to avoid damaging product over time. 3. Close washer door. 4. Press POWER/CANCEL. 5. Select CLEAN WASHER with affresh™ cycle. 6. Press and hold START/PAUSE. NOTE: The door will lock and the cycle will start. The washer will add some water, and the basket will rotate while the washer runs a short sensing cycle. This will take approximately 3 minutes. 7. The cycle will determine whether clothing or other items are in the washer. If no items are detected in the washer, it will proceed to Step 8. If any items are detected in the washer, a reminder will be displayed on the screen and the door will unlock. Open and remove any garments in the wash drum. Press POWER/CANCEL to cancel the error message. Then repeat steps 3-6 to start the cycle again. 8. Once the cycle has started, allow it to finish. If you must cancel the cycle before it has finished, press POWER/ CANCEL. A confirmation message will appear in the display. It may take up to 20 minutes for the door to unlock. 9. After the cycle has ended, leave the door open slightly, to allow for better ventilation and drying of the washer interior. To clean exterior: 1. Use a soft, damp cloth or sponge to wipe up any spills. 2. Use mild soap and water if needed. IMPORTANT: To avoid damaging washer finish, do not use abrasive products. 14