Netgear ME103 ME103 Reference Manual - Page 27
ON IRELESS, CCESS, EPLOY, admin, password - setup
UPC - 606449026375
View all Netgear ME103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Reference Manual for the ME103 802.11b ProSafe Wireless Access Point 2 CONFIGURE LAN AND WIRELESS ACCESS a. Configure the ME103 Ethernet port for LAN access. - Connect to the ME103 by opening your browser and entering http://192.168.0.224 in the address field. - When prompted, enter admin for the user name and password for the password, both in lower case letters. - Click the IP Settings link and configure the IP Settings for your network. b. Configure the wireless interface for wireless access. See the online help or the Understanding Basic Wireless Settings topic of the Reference Manual for full instructions. Note: You must set the Regulatory Domain. It may not be legal to operate the wireless access point in a region other than one of those identified in this field. Now that you have finished the setup steps, you are ready to deploy the ME103 in your network. If needed, you can now reconfigure the PC you used in step 1 back to its original TCP/IP settings. 3 DEPLOY THE ME103 ACCESS POINT a. Disconnect the ME103 and position it where you will deploy it. The best location is elevated, such as wall mounted or on the top of a cubicle, at the center of your wireless coverage area, and within line of sight of all the mobile devices. Tip: If you plan to locate the ME103 in a location where it is difficult to connect the electrical power supply, consider using the NETGEAR, Inc. POE101 Power Over Ethernet Adapter which provides power to the ME103 through the Ethernet cable. b. Lift the antenna on either side so that they are vertical. Note: Consult the antenna positioning and wireless mode configuration information in the Advanced Configuration chapter of the Reference Manual. Basic Installation and Configuration 3-6 August 2003