Nokia IP290 Installation Guide - Page 62
The connectors should be aligned with each other. The three screw holes and three standoffs
View all Nokia IP290 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
6 Installing and Replacing Components Other than Network Interface Cards Note If you are unable to slide out the chassis tray assembly, you might need to remove the shipping screw from the back of the appliance. For details, see Figure 5 on page 24. 1000BaseT LINK ACT SLOT 1 STATUS LINK ACT POWER FAULT AUX RESET CONSOLE 1 IP290 3 5 2 4 6 00563 6. Locate the PMC encryption accelerator card connector on the motherboard. The connector is located on the middle, left side of the motherboard. Caution Do not use the PMC connectors located at the front of the motherboard for the acceleration card. Those connectors are for the NICs. 7. Position the male PMC connector on the card over the female PMC connector on the motherboard. The connectors should be aligned with each other. The three screw holes and three standoffs should also be aligned with each other. 62 Nokia IP290 Security Platform Installation Guide