Nokia IP290 Installation Guide - Page 63
Configuring Software to Use Hardware Acceleration
View all Nokia IP290 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Replacing a Nokia Encryption Accelerator Card 8. Push down on the card until it is properly seated on the motherboard. 00568 9. Place the screws through the standoff holes on the card and into the standoffs on the motherboard. Screw Accelerator card Standoff hole Motherboard standoff 00175.1 10. Turn each screw clockwise to attach the card to the standoffs. Do not overtighten. Make sure that all standoff connections are properly aligned before tightening the screws completely. 11. Slide the chassis tray assembly back into the appliance. 12. Resecure the two chassis tray assembly retaining screws. Note When you resecure the chassis tray assembly retaining screws, do not exceed a torque of 4.5 inch-pounds. 13. Replace the power cord. 14. Turn on the power. 15. Configure your software to use hardware acceleration by following the instructions in "Configuring Software to Use Hardware Acceleration" on page 64. Nokia IP290 Security Platform Installation Guide 63