NordicTrack Grt490 English Manual - Page 20
Ble-shooting And Maintenance
View all NordicTrack Grt490 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
45. Attach the upper end of the Shroud (56) to the two "L"-brackets on the Top Frame (1) with two 1/4" x 3/4" Bolts (17), two 1/4" Flat Washers (71), and two 1/4" Nylon Locknuts (25). Make sure that the indicated corner of the Shroud is lined up with the indicated corner of the Top Frame. The Bolts must be inserted through the square holes in the Shroud. Do not tighten the Bolts yet. 45 "L"-Brackets Align Corners 1 71 17 17 71 25 56 46. Attach the lower end of the Shroud (56) to the bracket 46 on the Stabilizer (5) with four #8 x 3/4" Screws (32). The Screws must be inserted through the square holes in the Shroud and into the Tinnerman Clips (38). Tighten the bolts used in step 45. 38 38 5 Bracket 47. Insert a 1" Round Inner Cap (103) into each end of the Lat Bar (61). 47 103 32 56 61 32 32 103 48. Attach the Curl Pad (21) to the Curl Post (83) with 48 four 1/4" x 3/4" Bolts (17). 49. Make sure that all parts have been properly tight- ened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 22 of this manual. 17 Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. 21 83 IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE-SHOOTING AND MAINTENANCE on page 24. 20