Olympus C7000 Zoom C-7000 Advanced Manual - Page 162

Troubleshooting Possible cause Corrective action Ref. page Halation produces unnatural colors in the picture. This may be caused by Use a UV filter. As this may upset the overall - excessively bright color balance, it should only be used in the ultraviolet light on the conditions described on the left. subject, such as sunlight If the discoloration persists, touch up the shining through the picture using a graphics application. For leaves of trees, window details, refer to the manual for the graphics frames in bright light at application you are using. night, reflection of metal in direct sunlight, etc. Pictures you have taken do not appear on the monitor. The power is off. Set the mode dial to q, then press the POWER switch to turn the camera on. P.12 The camera is in the shooting mode. Press the QUICK VIEW button or set the mode dial to q. P.12, 13 There are no pictures on "NO PICTURE" is displayed on the monitor. - the card. Record pictures. There is a problem with See "Error codes". the card. P.156 The camera is connected to a TV. The monitor does not function when the AV cable is connected to the camera. P.96 Single-frame erase and all-frame erase cannot be performed. The pictures are Display pictures with 9 and press the 0 protected. button to cancel protection. P.98 No picture is displayed on the TV when connected to the camera. The video output signal Set the video output signal according to the is incorrect. region where used. P.97 The TV video signal setting is incorrect. Set the TV to the video input mode. P.96 The monitor is hard to see. The brightness of the Select [s] in the mode menu and adjust the P.114 monitor is not adjusted brightness. properly. 10 The monitor is exposed Block the sunlight with your hand or use the - to direct sunlight. viewfinder. Appendix 162