Onkyo TX-NR809 Owner Manual - Page 67

Controlling Zone 2/3 Components ■ Operating on the AV receiver Input selector buttons MASTER VOLUME ■ Operating on the remote controller To control Zone 2/3, you must press the remote controller's ZONE first. ZONE turns red while Zone 2 is on, and green while Zone 3 is on. RECEIVER ZONE Input selector buttons ZONE 3 ZONE 2 OFF 1 To turn on Zone 2/3 and select an input source, press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds. Zone 2/3 turns on, the Z2/3 indicator lights on the display. Tip • The corresponding trigger output goes high (+12 V). To select AM or FM, press TUNER input selector and ZONE 2 or ZONE 3 repeatedly. To select the same source as the main room's, press ZONE 2 or ZONE 3 twice. "Z2 Selector: Source" or "Zone 3 Selector: Source" appears on the display. To turn off Zone 2/3, press ZONE 2 or ZONE 3. The Z2/3 indicator on the display flash. Press OFF. The zone is turned off. Tip • The corresponding trigger output goes low (0 volts). MUTING VOLR/X 1 Press ZONE repeatedly, then point the remote controller at the AV receiver and press RECEIVER. Zone 2/3 turns on, the Z2/3 indicator lights on the display. Tip • The corresponding trigger output goes high (+12 V). 2 To select an input source for Zone 2/3, press ZONE repeatedly, followed by INPUT SELECTOR. To select AM or FM, press the TUNER input selector and ZONE repeatedly. Note • You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room. 3 To turn off Zone 2/3, press ZONE repeatedly, followed by RECEIVER. Tip • The corresponding trigger output goes low (0 volts). En 67