Panasonic BT-LH1850 Operating Instruction - Page 13
Power supply, Connecting the power cable, Adjusting monitor angle
View all Panasonic BT-LH1850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Power supply Connecting the power cable 1. Attach the power cable to the unit. When using external DC power (12 V DC) You can slide open the power cover to switch from AC input to external DC input. Power cover Power cable 2. Connect the power cable to an AC outlet. • If the power cover has come off or been removed, do not use the monitor with the power supply connected to both AC input and DC input terminals. • Use a shielded DC cable that is not longer than 2 m. A cable that is 2 m or longer may cause noise. If an external DC power supply is used, be sure to check that the rating of the external DC power supply suits the power requirements of this unit. When using external DC power (12 V DC), check the external DC input terminal pin signal, and use the correct polarity. If a +12 V power supply is accidentally connected to the GND terminal, this could cause a fire or personal injury. 1 2 4 3 External DC input terminal Pin number 1 2, 3 4 Signal GND ― +12 V Adjusting monitor angle Move the unit in the direction of the arrows to adjust it to a comfortable viewing position. Approx. 10 degrees Approx. 15 degrees Forward Backward • The tilt stand allows you to tilt the unit approx. 10 degrees forward and approx. 15 degrees backward. 13