Panasonic BT-LH1850 Operating Instruction - Page 37

Main menu (continued) „„FOCUS-IN-RED FOCUS-IN-RED shows the outline of a subject that is in focus in red to simplify focusing the camera. Each press of the button ("FUNCTION1" to "FUNCTION5") to which the FOCUS-IN-RED has been assigned turns the function on and off. • To use the FOCUS-IN-RED function, it must be assigned to one of the "FUNCTION1" to "FUNCTION5" functions. When the FOCUS-IN-RED function is displayed, use the rotary knob to change detection sensitivity level (0 - 30). A higher numerical value results in higher detection sensitivity (outlines are displayed in red even when they are not properly focused). If you set CHROMA to 0 or assign "MONO" to another function button to switch to monochrome, the focus will become easier to check. The foreground is in focus Push once the FUNCTION button to which the FOCUS-IN-RED function is assigned. Normal screen FOCUS-IN-RED display Press the button again The background is in focus The outlines in focus are displayed in red Press the button again These examples show 16:9 aspect ratio images. GPI "GPI CONTROL" is used to enable and disable GPI functions and assign functions to each of the GPI input terminal pins (→page 44) The underlined values are factory preset setting values. Sub menu Settings Description GPI CONTROL DISABLE ENABLE Enables and disables GPI functions Disabled Enabled GPI1 - GPI8 UNDEF MARKER1 ON/OFF MARKER2 ON/OFF MARKER BACK HALF MARKER BACK BLACK CENTER MARKER CROSS MARKER INPUT SEL. VIDEO INPUT SEL. SDI1 INPUT SEL. SDI2 INPUT SEL. HDMI INPUT SEL. DVI-I INPUT SEL. INT SG SD ASPECT SCAN R-TALLY G-TALLY MONO GAMMA SEL. FILM GAMMA SEL. STDIO/PST PIXEL TO PIXEL FOCUS-IN-RED REMOTE STANDBY Assigns functions to the GPI input terminal pins. The same items can be set to each terminal (→page 44). • Operation may not be possible depending on the setting conditions. Example: "SD ASPECT" operation when input signal is HD 37