Panasonic WJ-HDE400/3000T3 Installation Guide - Page 13
Cable clamp
View all Panasonic WJ-HDE400/3000T3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
● Cable clamp Fix the connection cable using the provided cable clamp as follows. 1 Attach the cable clamp fixing belt to the fixing hole on the rear, and pass the cable through the holder part of the cable clamp. Pull the cable clamp fixing belt to confirm that the fixing belt is attached firmly. Cable clamp fixing belt Holder part 2 Close the clamp. Note: • Overhead view (1) Knob (1) (2) Clamp Connector end of the connection cable (1) Hold the connector end of the connection cable by tightening the clamp. It may be difficult to hold the connector end when the cable clamp is not slid all the way to the connector end side. (2) To slide the cable clamp in the direction of arrow indication (2), slide it while keeping the knob pulled down. 3 Slide the cable clamp toward the connector end of the connection cable, and then hold the connector end of the connection cable. Make sure that the connection cable is connected firmly. 13