Panasonic WJ-HDE400/3000T3 Installation Guide - Page 7
Precautions
View all Panasonic WJ-HDE400/3000T3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Precautions Do not operate this product beyond its specified temperature, humidity, or power source ratings. Use this product at temperatures between 5 °C to 45 °C {41 °F to 113 °F} and where the humidity is between 5 % to 90 %. The input power source for the NTSC model is 120 V AC 60 Hz, and for the PAL model is 220 V to 240 V AC 50 Hz.* Performance and lifetime of hard disk drives are easily affected by heat (used at high temperature). It is recommended to use this product at temperatures between 20 °C to 30 °C {68 °F to 86 °F}. * The provided power cords are dedicated to the use with this product. POWER switch The POWER switch is located at the rear of this product. Even though the POWER switch is set to "OFF", the power supply will not be cut. To cut the power supply, remove the power plug of this product from the AC outlet. When using the power supply control unit, turn off the power of the power supply control unit. Hard disk drive (HDD) • Hard disk drives are vulnerable to vibration. Handle them with care. It is possible to damage them if they are moved while their motors are still running. • Do not move them just after turning the power off (for around 30 seconds). • The lifetime of hard disk drives is limited by use. Write errors may occur frequently after around 20 000 hours of operation, and the head and motor deterioration may occur after 30 000 hours of operation. They will reach the end of their lifetime after 30 000 hours of operation if they have been used at the recommended ambient temperature (approx. 25 °C {77 °F}). • It is recommended to replace them after around 18 000 hours of operation to prevent data loss from disk failures. • When hard disk drive trouble occurs, replace it immediately. Contact your dealer about servicing. Prevent condensation from forming on the surface of the hard disk drive. If this happens, do not turn on the power of this product. Instead leave it switched off for around 2 hours. Wait until the dew evaporates in any of the following cases: • This product is placed in an extremely humid place. • This product is placed in a room where a heater has just been turned on. • This product is moved from an air-conditioned room to a humid or high-temperature room. When this product has not been used for a certain period, turn on the power (approximately once a week), and perform recording/playback to prevent interferences with functions. Cleaning • Turn the power off when cleaning this product. Otherwise it may cause injuries. • Do not use strong or abrasive detergents when cleaning the body. Use a dry cloth to clean this product when it is dirty. • When the dirt is hard to remove, use a mild detergent and wipe gently. • When using a chemical cloth for cleaning, read the caution provided with the chemical cloth product. Product disposal/transfer Data saved on the hard disk drive may lead to personal information leakage. When it is necessary to dispose of or give this product to someone, even when for repair, make sure that there is no data on the hard disk drives. Indication label Refer to the indication label placed on the surface of this product as to the indications of equipment classification and power source, etc. Handle this product with care. Do not strike or shake, as this may damage this product. Do not strike or give a strong shock to this product. It may cause damage or allow water to enter this product. 7