Panasonic WJ-HDE400/3000T3 Installation Guide - Page 25
Install link all the HDD units in the, extension unit at the same time
View all Panasonic WJ-HDE400/3000T3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
11 Move the underscore mark below "YES" using the arrow button (left or right), and then press the [SET] button. The installed HDD unit will be recognized as the HDD units for recording use. When the [SET] button is pressed, the display on the LCD will return to the time and date menu. 12 Close the front cover and lock it by pushing and turning the key to the left. • Keep the key in a safe place. (2) (1) 13 Check the disk information. The following can be checked on the "Disk information" page on the setup menu of the recorder. Refer to the manuals provided with the recorder for further information. • Total capacity of the hard disk drive • Available (remaining) capacity of the hard disk drive • Hour meter • Operational mode of the hard disk drive • Time and date range of the images recorded on the hard disk drive. Note: • It is impossible to add a hard disk drive when running the system in the RAID 5 or RAID 6 mode. Even if an HDD unit is installed (linked) in an empty HDD slot, it will not be added to the RAID array. • It is possible to install (link) all the HDD units in the extension unit even when the operational mode is "RAID5" or "RAID6". * When using a recorder (not a network disk recorder), refer to the manuals provided with the recorder for how to operate. ● Install (link) all the HDD units in the extension unit at the same time It is possible to make all the HDD units in the extension unit available (make them linked) at the same time. Refer also to the manuals provided with the recorder. 1 Install the HDD units in the extension unit. Install the HDD units by following steps 1 and 2 of the "Install the HDD units (page 24)" section. When installing 2 or more HDD units, repeat steps 1 and 2. Note: • When installing 2 or more HDD units, do not install the units at one time. Only after the recognition process of a single HDD unit is complete, install the next HDD unit by following steps 1 and 2. 2 Recognition process of the hard disk drive will start automatically. • The HDD status indicator will blink orange during the rec- ognition process. When the recognition process is complete, the HDD status indicator will light or blink green. • When the inserted hard disk drive is unformatted, format- ting will start automatically. When formatting is complete, the HDD status indicator will light green. • When the inserted hard disk drive is formatted, it will be recognized as the hard disk drive for playback use only. In this case, the HDD status indicator will blink green. To use it for recording, follow the instructions from step 3. The following operations are to be performed on the network disk recorder after the recognition process is complete.* 3 Hold down the [USE] button for 2 seconds or more. The buzzer will sound. 4 Press the arrow button (up or down) repeatedly until the "HDD Operation" indication is displayed. 5 Press the [SET] button. 25