Panasonic WJ-HDE400/3000T3 Installation Guide - Page 24
Install the HDD units
View all Panasonic WJ-HDE400/3000T3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
● Install the HDD units It is possible to install the HDD units without stopping the operation. Refer also to the manuals provided with the recorder. 1 After inserting the provided key into the key hole on the front cover, push and turn it to the right to open the front cover. (1) • When the inserted hard disk drive is formatted, it will be recognized as the hard disk drive for playback use only. In this case, the HDD status indicator will blink green. To use it for recording, follow the instructions from step 4. Note: • The HDD status indicator sometimes may light green before blinking orange when a hard disk drive is inserted. The following operations are to be performed on the network disk recorder.* 4 Hold down the [USE] button for 2 seconds or more. The buzzer will sound. 5 Press the arrow button (up or down) repeatedly until the "HDD Operation" indication is displayed. (2) 2 Insert the HDD units into the HDD slots in order starting from HDD1. Lift the lever on the HDD unit while holding down the removal knob, and then insert the HDD unit all the way into the HDD slot. (1) Pinch the tab on the HDD slot with the hook on the HDD unit securely. (2) Press the lever down and push it until the removal knob clicks. (1) (1) 6 Press the [SET] button. 7 Press the arrow button (up or down) repeatedly until the "Link HDD" indication is displayed. 8 Move the underscore mark below "YES" using the arrow button (left or right), and then press the [SET] button. 9 Select the device in which the HDD unit is installed (recorder: MAIN, extension unit (x): EXTx) using the arrow button (up or down), and then press the [SET] button. (2) 3 Recognition process of the hard disk drive will start automatically. • The HDD status indicator will blink orange during the rec- ognition process. When the recognition process is complete, the HDD status indicator will light or blink green. • When the inserted hard disk drive is unformatted, format- ting will start automatically. When formatting is complete, the HDD status indicator will light green. 24 10 Select the HDD slot number to which the HDD unit is to be inserted using the arrow button (up or down), and then press the [SET] button.