Panasonic WJ-HDE400/3000T3 Installation Guide - Page 26

6 Press the arrow button (up or down) repeatedly until the "Link EXT" indication is displayed. 7 Move the underscore mark below "YES" using the arrow button (left or right), and then press the [SET] button. 8 Select the HDD slot number to which the HDD unit is to be inserted using the arrow button (up or down), and then press the [SET] button. 9 Move the underscore mark below "YES" using the arrow button (left or right), and then press the [SET] button. • Total capacity of the hard disk drive • Available (remaining) capacity of the hard disk drive • Hour meter • Operational mode of the hard disk drive • Time and date range of the images recorded on the hard disk drive. * When using a recorder (not a network disk recorder), refer to the manuals provided with the recorder for how to operate. ● Remove the HDD units It is possible to remove the HDD unit without stopping the operation. Refer also to the manuals provided with the recorder. 1 After inserting the provided key into the key hole on the front cover, push and turn it to the right to open the front cover. (1) All the installed HDD units will be recognized as the HDD units for recording use. When the [SET] button is pressed, the display on the LCD will return to the time and date menu. 10 Close the front cover and lock it by pushing and turning the key to the left. Keep the key in a safe place. (2) (2) The following operations are to be performed on the network disk recorder.* 2 Hold down the [USE] button for 2 seconds or more. The buzzer will sound. 3 Press the arrow button (up or down) repeatedly until the "HDD Operation" indication is displayed. (1) 11 Check the disk information. The following can be checked on the "Disk information" page on the setup menu of the recorder. Refer to the manuals provided with the recorder for further information. 4 Press the [SET] button. 5 Press the arrow button (up or down) repeatedly until the "Remove HDD" indication is displayed. 26