Panasonic WJ-HDE400/3000T3 Installation Guide - Page 20
Reset the settings to the default
View all Panasonic WJ-HDE400/3000T3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
■ Reset the settings to the default To reset the settings of the extension unit to the default, do the following. Important: • When the settings are reset to the default, it may become impossible to access data on the hard disk drives since the disk configuration settings are invalidated. Start resetting the settings after confirming that all data on the hard disk drives can be deleted. • Contact your dealer before resetting the settings. 1 Turn on the power of the extension unit by pressing the [POWER] switch while holding down the [SET] button until the "INIT.SETUP" indication is displayed. 2 Move the underscore mark below "YES" using the arrow button (left or right), and then press the [SET] button. 3 Reset of the settings will start. 4 When the reset of the settings is complete, he fol- lowing indication will be displayed. When the reset fails, the "FAILURE" indication will be displayed. In this case, start resetting the settings from step 1 again. 5 Turn on the power of the extension unit again, and then install (link) all the HDD units in the extension unit by following the instructions in the "Install (link) all the HDD units in the extension unit at the same time (page 25)" section. 20