Pfaff ClassicStyle 2027 Owner's Manual - Page 23

To change

Get Pfaff ClassicStyle 2027 PDF manuals and user guides View all Pfaff ClassicStyle 2027 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Preparations Disengaging the IDT Hold the IDT with two Àngers at the ribbed ankle. Press the IDT (14) down, then pull it away from you and release the IDT slowly upward. Lowering the feed dog For certain sewing work such as free-motion quilting or darning and when the machine must be cleaned, the feed dog has to be lowered. To do this, open the bobbin door (26) and press slide B fully to the right. Now the feed dog is lowered. To B switch on the feed dog press slide B to the left. Raise the presser foot before lowering or raising the feed dog. Altering stitches A Adjust the length, width, balance, density or needle position of stitches by touching the appropriate -/+ buttons to the right of B the window. Each change is visible in the window. If you tap on your foot control while sewing, the needle can be C raised or lowered. This does not change the pre-set needle stop position To change: Stitch width Pattern width Needle position for straight stitches Stitch length Pattern length Stitch density Pattern density Balance Use -/+ buttons: A B C 2:13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
2:13
B
A
B
C
Preparations
Disengaging the IDT
Hold the IDT with two
À
ngers at the ribbed ankle. Press the
IDT (14) down, then pull it away from you and release the IDT
slowly upward.
Lowering the feed dog
For certain sewing work such as free-motion quilting or
darning and when the machine must be cleaned, the feed dog
has to be lowered. To do this, open the bobbin door (26) and
press slide B fully to the right. Now the feed dog is lowered. To
switch on the feed dog press slide B to the left.
Raise the presser foot before lowering or raising the feed dog.
Stitch width
Pattern width
Needle position for straight stitches
A
Stitch length
Pattern length
B
Stitch density
Pattern density
Balance
C
To change:
Use -/+ buttons:
Altering stitches
Adjust the length, width, balance, density or needle position of
stitches by touching the appropriate -/+ buttons to the right of
the window. Each change is visible in the window.
If you tap on your foot control while sewing, the needle can be
raised or lowered. This does not change the pre-set needle stop
position