Pioneer CDJ-500II Owner's Manual - Page 22
Troubleshooting - cd
View all Pioneer CDJ-500II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
TROUBLESHOOTING Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work. Symptom Cause Remedy Door is not expelled when EJECT is ÷ Power plug is disconnected from outlet. pressed. ÷ Connect plug to wall outlet. When playback is started, it stops ÷ Disc is loaded upside down. immediately. Pauses or stops during ÷ Smudges on the disc, etc. playback. ÷ Load the disc correctly with the label side UP. ÷ Clean the smudges from the disc and then play it again. No sound ÷ Output cables are connected incorrectly or loosely. ÷ Incorrect operation of audio mixer. ÷ Pin plugs and/or amplifier terminals are dirty. ÷ Player is in pause mode. ÷ Connect properly. ÷ Check the settings of audio mixer switches and sound volume controls. ÷ Clean away dirt. ÷ Press the PLAY/PAUSE button. Sound is distorted, noise is output. ÷ Incorrect connections. ÷ Pin plugs and/or amplifier terminals are dirty. ÷ Interference is being picked up from a TV set. ÷ Connect to audio mixer's LINE INPUT terminals. Do not connect to MIC terminals. ÷ Clean away dirt. ÷ Switch OFF TV set, or move player away from TV set. With certain discs, loud noise is ÷ Disc has a bad scratch or warp. produced, or play stops. ÷ Disc is extremely dirty. ÷ Replace the disc. ÷ Clean disc. When the auto cue function is set to ON, track search is not finished. ÷ If the sound muted portion between selections is long, searching time will be long. ÷ If the sound muted portion is recorded for about 20 seconds or more, playback will start without the auto cue function. ÷ Press TIME MODE/AUTO CUE button for more than 1 second, and set the auto cue function to OFF. Back cue function cannot be carried ÷ The cue point is not set yet. out even though the CUE button is pressed in playback mode. ÷ Set the cue point. (See page 16.) Loop playback cannot be carried out ÷ The cue point (loop in point) is not set yet. even though the LOOP OUT//EXIT button is pressed. ÷ Set the cue point. (See page 16.) The picture of the TV screen is ÷ Interference is being picked up from the CD ÷ Turn off POWER of the player, or move the fluctuated or FM broadcast is player. player away from TV or tuner. interfered with noise. The disc is not rotating when the power is ON. ÷ The disc rotation stops automatically if no operation has been performed for 80 minutes or more in pause mode. ÷ Playback can be started by pressing the PLAY/ PAUSE button. If the EJECT button is pressed, the door will open. Abnormal functioning of this unit may be caused by static electricity, or other external interference. To restore normal operation, unplug the AC power cord and then plug it in again after the disc completely stops. 22 En