Pioneer CDJ-500II Owner's Manual - Page 24

TROUBLESHOOTING Error display When the player cannot be operated correctly, an error code number appears in the display window. When the displayed error code number is in the table below, confirm the cause of the trouble and solve it. If the cause of trouble is unknown, remedy is too difficult or the same error code number is displayed after it is remedied, please contact your nearest PIONEER authorized service center and refer to the error code number. Displayed error code number Type of error E-72 01 TOC READ ERROR E-83 01 E-83 02 PLAYER ERROR PLAYER ERROR E-91 01 MECHANICAL TIME OUT E-91 02 MECHANICAL TIME OUT E-91 03 MECHANICAL TIME OUT Error contents Cause = Remedy TOC data on the disc cannot be read even after 20 seconds have passed. A disc cannot be played normally. (GFS NG) A disc is dusty or dirty. = Clean the disc. A disc is cracked. = Replace the disc. A disc cannot be played normally. (FOCUS NG) Mechanism operation is not completed within the specified time. (CLAMP) Mechanism operation is not completed within the Foreign object is in the disc specified time. (OPEN) compartment. = Remove it. Mechanism operation is not completed within the specified time. (INSIDE) SPECIFICATIONS 1. General System Compact disc digital audio system Power requirements ....... AC 110/120/220 - 230/240 V (switchable) 50/60 Hz Power consumption 21 W Operating temperature 5˚C - +35˚C (+41°F - +95°F) Operating humidity 5% - 85% (There should be no condensation of moisture.) Weight 4 kg (8 lbs 13 oz) Dimensions 320 (W) X 362.1 (D) X 98.5 (H) mm 12-5/8 (W) X 14-1/4 (D) X 3-7/8 (H) in 2. Audio section Frequency response 4 Hz - 20 kHz (EIAJ) Signal-to-noise ratio 106 dB or more (EIAJ) Dynamic range 96 dB or more (EIAJ) Channel separation 98 dB or more (EIAJ) Total harmonic distortion 0.004% or less (EIAJ) Output level 2.0 V (EIAJ) Channels 2-channel (stereo) 3. Other terminal CONTROL miniature jack 4. Functions ÷ Top loading disc compartment ÷ Pick-up protector ÷ Sliding type speed control (TEMPO control knob) ÷ Immediate playback ÷ Realtime loop ÷ Re-loop ÷ loop out point adjustment ÷ Master tempo control ÷ Fader start (*) ÷ Fader stop (back cue) (*) 24 En ÷ Relay playback (using the CONTROL jack) ÷ Auto cue (ON/OFF) ÷ Cue point monitor ÷ Back cue ÷ Beat search with the Jog dial ÷ Frame search with the Jog dial ÷ Manual search with the Jog dial ÷ High-speed manual search ÷ Cyclical track search ÷ Switching of the TIME display (TIME/REMAIN) ÷ Auto spindle stop (*) Available when combined with PIONEER DJM-500 or DJM-300 DJ mixer. 5. Accessories ÷ Operating instructions 1 ÷ Audio cable 1 ÷ Control cable 1 ÷ Screws for rack mounting 4 ÷ Spacers for rack mounting 4 NOTE: Specifications and design subject to possible modification without notice, due to improvements. Maintenance: In order to ensure the safe and correct function of this unit, we recommend regular maintenance. Extended service life can be expected if maintained properly. Published by Pioneer Electronic Corporation. Copyright © 1997 Pioneer Electronic Corporation. All rights reserved.