Pioneer DJM-700 Owner's Manual - Page 25
Troubleshooting - used mixer
UPC - 012562860862
View all Pioneer DJM-700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
TROUBLESHOOTING TROUBLESHOOTING Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component, check the points below. Sometimes the trouble may originate from another component. Thus, also check the other electrical appliances also in use. If the trouble cannot be rectified even after checking the following items, contact your dealer or nearest PIONEER service center. Symptom Possible Cause Remedy No power • The power cord has not been connected. • Connect to power outlet. No sound, or sound volume is too low. • Input selector is set incorrectly. • Connection cables are connected incorrectly, or connections are loose. • Jacks or plugs are dirty. • The rear panel master output attenuator switch (MASTER ATT) is set to -6 dB, etc. • Set input selector to playback component. • Connect correctly. • Clean soiled jacks/plugs before connecting. • Adjust rear panel master attenuator switch (MASTER ATT). No digital output. • The digital output sampling frequency (fs) does • Set rear panel sampling frequency selector to not match the specifications of the connected match the specifications of the connected component. component. Sound is distorted. • Master output level is too high. • Input level is too high. • Adjust master output level (MASTER LEVEL) dial or the rear panel master output attenuator (MASTER ATT) switch. • Adjust the TRIM dial so that the input level approaches 0 dB on the channel level indicator. Cross fader doesn't work. • CROSS FADER ASSIGN switch setting ([A], [THRU], [B]) is incorrect. • Correctly set the CROSS FADER ASSIGN switch for the desired channel. Can't perform fader start with CD player. • The FADER START button is set to OFF. • Rear panel CONTROL jack is not connected to CD player. • Only the rear panel CONTROL jack is connected to the CD player. • Set the FADER START button to ON. • Use a control cable to connect the CONTROL jacks of mixer and CD player. • Connect both the CONTROL jacks and analog input connectors. Effects don't work. • Effect channel selecter setting is incorrect. • Effect parameter 2 adjust dial (LEVEL/DEPTH) is set to [MIN]. • Correctly select the channel on which you wish to apply effects. • Adjust the effect parameter 2 adjust dial (LEVEL/DEPTH). External effector doesn't work. • Effect selecter is not set to [SND/RTN]. • Effector is not connected to rear panel SEND/ RETURN connector. • Effect channel selector is set to incorrectly. • Set effect selector to [SND/RTN]. • Connect effector to the rear panel SEND/ RETURN connectors. • Use the effect channel selector to select the audio source to which you wish to apply the effects. Sound from external effector is • Input level from external effector is set too high. • Lower the output level of the external effector. distorted. BPM can't be measured. Measured BPM value is incorrect. • Input level is too high, or too low. • BPM may not be correctly measurable with some tracks. • Adjust the TRIM dial so that the input level approaches 0 dB in the channel level indicator. • Adjust other channels as well so that the input levels approach 0 dB in the channel level indicator. • Strike the TAP button to set BPM manually. The measured BPM value is different from the value published with the CD. • Some differences may occur due to differences • No remedy is necessary. in BPM detection methods. MIDI sequencer can't be synchronized. • MIDI sequencer's synch mode is not set to "slave". • MIDI sequencer is not supported type. • Set MIDI sequencer's sync mode to "slave". • MIDI sequencers that do not support MIDI timing clock cannot be synchronized. Static electricity or other external interference may cause the unit to malfunction. To restore normal operation, turn the power off and then on again. 25 En