ProForm 785 Treadmill English Manual - Page 5

ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. A phillips screwdriver (not included) may be needed for assembly. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. 1. With the help of a second person, carefully raise the Uprights (71) until the treadmill is in the position 1 shown. 71 2. Insert the top halves of the Left and Right Base Mounts 2 (78, 104) into the Uprights (71) as shown. 78 71 104 71 3. Slide the plastic pins on the sides of the Console Base (91) into the Left and Right Base Mounts (78, 104). Refer to inset drawing B. Connect the Wire Harness (85) to the Console Wire Harness (114). Connect the 54" Hand Pulse Wire (95), the 25" Hand Pulse Wire (83) and the 4" Ground Wire (82) to the Pulse Wire Harness (77) (make sure that the Wires with tags are connected to each other). Refer to inset drawing A. Carefully feed all wires into the hole in the Upright (71) as shown. Make sure that the wires are routed through the notch in the base mount and under the plastic pin. Be careful not to pull on the wires or they may become permanently damaged or disconnected from the console. 3 104 O A 0 71 B Pin Notch 71 0 95 83 2 =CA 82- r:=O 91 78 O ) 77 5